OM3RKP  
Presentation

+ About us
+ DX Cluster
+ Ham stuff
+ OM3RKP
+ OM3RKP Log
+ Results 2005
+ Results 2006
+ Results 2007
+ Satellites
+ Stories 2005
+ Stories 2006
+ Stories 2007
+ Stories 2008
+ Weak signal communication

Technical corner

+ Constructions
+ Hints&kinks

Google
Gallery

 

OM3RKP webcam
OM3RKP webcam
Click on the picture for actual picture
Vistors

 60900 visitors

 4 visitors online

WI-FI antenna

Look through the WI-FI antennaWI-FI band (2.45 GHz) is not so far from 2.3 GHz what is a radioamateur band 13 cm. An idea of G6KSN was the base how to build own WI-FI antenna.

I have compared three WI-FI antennas: original from AP, home made DL7KM (twin quad) and 10-element yagi loop. The last is the best. It's not a problem to copy signal from AP in distance 4.5 km!

The building is relative easy (easier than it looks). Things needed: PCB, N-type connector, piece of thin 50 ohm coax, some Cu wire with 1,5 mm diameter, Cu tube 8 – 12 mm, knife, soldering iron, etc.

An inspiration for building this antenna is an article http://www.paramowifix.net/antenas/loop_uda_yagi/. This looks a little bit too long. I choose smaller version with 10 elements. Total lenght of mine antenna does not exceed 30 cm.

WI-FI antenna


Here is an output from programm:
An output from G6KSN programm


ReflectorReflector was made from a piece of PCB. Diameter of the ring is near the same like diameter od CD. Drill a hole for N-type connector. With a soldering iron connect to the reflector boom (Cu tube).

Make the marks on tube in the element positions. Elements are made from Cu wire. Each ring was made so: cut an exact length of Cu wire for element (for example 135 mm). Wind it on a tube with a little bit smaller diameter how the ring should have.

Design of WI-FI antenna



Hold the elements in a position and connect them to the boom with a soldering iron. The driven element is cutted in the half. There is connected a piece of coaxial cable (RG-58, semirigit, etc.). The other end is going to the N-type connector. Leads should be short as possible!

Mechanical construction:

A detail of driven element
Short piece of coax
N-type connectorAn elements of WI-FI antenna


A program Loop Yagi CALC You could obtain .: HERE :.. Antenna was sucesfully tested and used on WI-FI band. But there is a premise that it should work good also on radioamateur bands. Be careful with a polarizations of signal, especially on WI-FI (horizontal, vertical, mix). Setting-up for best signal needs few minutes.


Creation date : 29/12/2006 @ 10:09
Last update : 29/12/2006 @ 10:09
Category : Constructions


Print preview Print preview     Print the page Print the page

Amateur Radio Sites
VHF propagation
Es status
Es status
Au status
Es status
Search




RSS
Info
Write to OM0AAO Viliam  Webmaster
Add to favourites  Favorites
Recommend this site to a friend  Recommend
mobile Version   mobile Version
   up  Top  up  

Recommending: An accommodation in Tatranska Lomnica - cottage Biela Stopa. DX shack rental - available HF setup: Yaesu FT-1000MP + Heathkit PA + yagis + wires + beverage

Site running with GuppY v4.0.3 - CeCILL free License - © 2004-2006